, ,

110V/60Hz/1ph – 10000LB – 3HP Hydraulic Pump Power Ramp Truck Hoist Unit – Two Post – Car Lift Auto Floor Plate Vehicle


1.Low-profile, dropped-end frame contact pads From race cars to lowered compact vehicles, this car lift has the versatility to get under your chassis without damaging your vehicle’s body or frame.
2.Lifts come with free set of Truck adapters Highly duty oil slider with 10mm steel rope ensures carriage smooth moving up and down. With 8 folded profile column, provide extremely high strengthen working ability.
3.Symmetric arms design with double lock system The highly sophisticated yet simple and dependable HPDMC Series design requires very little service or maintenance for an overall lower cost of ownership.


Control System:
•Lifting operation by pressing "UP" button on motor
•Manual lowering operation by pressing lever
•Relief valve built in power pump to prevent overloading
•1 sets truck adapters included

Lifting Capacity: 10,000 lbsLift Speed: 50 Seconds
•The overall Height  110-1/4"
•The overall Width  139-3/4"Arm size: 30-3/4”  –   50-3/8” ( 780-1280mm)    
•Min pad height: 3-3/4"(95mm)
•Lift height max: 70-1/16"(1780mm)
•Drive-thru width clearance: 109-1/4" (2775mm)
•Time to full rise: 20-60 sec


Before installing your auto lift, check the following:
• Lift Location: Always use architect’s plans when available.  Check layout dimension against floor plan requirements making sure adequate space is available.  Your lift
requires a 220v, 30amp, single phase, grounded electrical source.  There should be room enough to operate the lift in a safe manner and without restrictions.
• Overhead Area: The area where the lift will be located should be free of overhead obstructions such as heaters, building supports, electrical lines, doors, lights, etc.
• Floor Area: Visually inspect the site where the lift is to be installed and check for cracked or defective concrete.

Floor Requirements
• A level floor is suggested for proper installation and level lifting.  Small differences in floor slopes may be compensated for by proper shimming.  If a floor is of questionable slope, consider a survey of the site and/or the possibility of pouring a new level concrete slab.
• New concrete must be adequately cured for at least 30 days.

DO NOT install auto lift on any asphalt surface or any surface other than concrete.
DO NOT install auto lift on expansion seams or on cracked or defective concrete.
DO NOT install auto lift on a second/elevated floor without first consulting building architect.
DO NOT install auto lift outdoors unless special consideration has been made to protect the power unit from inclement weather conditions.

Concrete Specifications
All models MUST be installed on 3,000 PSI reinforced concrete only.  Additional concrete requirements will vary by lift.

SKU: AA2PFP45-110V-1 Categories: , ,